Upload a floor plan or a fire protection layout. BildVisor reads what is on the drawing and pulls it into a table you can check and export.
Alpha
Component and device identification
Zone by zone counts
Equipment schedule extraction
Export to a table
It reads what is already drawn. Deciding what should be drawn stays with your professional.
level-04.dwg, extracted
Zone
Device
Count
Open office
Smoke detector
12
Open office
Sprinkler head
34
Server room
Clean agent nozzle
4
Corridor
Manual call point
3
Stair A
Hose reel
1
Basement
Hydrant
2
What the standard asks for
Type
By fire class
Class A, B, C, D, E and F each take a different agent. CO2 for live electrical, wet chemical for cooking oil.
Capacity
1 unit per 200 sq m
At least one unit of 1A rating per 200 sq m of floor area, minimum one per floor.
Height
1.0 m to 1.5 m
Measured to the handle, with the base clear of the floor and the unit on a bracket or stand.
Cited from IS 2190Deciding where it goes on your drawing stays with the professional who signs the design.
Answered with the clause
Example answerPending verification
What spacing applies to smoke detectors on a flat 4 m ceiling in an open office?
The answer appears here, in plain English, with the figure the standard actually gives.
IS 2189, Clause 0.0, p. 00
Indexed and searchable, with clause level citations
IS 2189Fire alarm and detection
IS 15105Sprinkler systems
IS 15325Water spray and deluge
IS 15301Fire pumps
IS 15493Clean agent suppression
IS 2190Portable extinguishers
NBC Part 4Fire and life safety
State fire rulesYour approval authority
Which edition applies
NBCS 2026 replaced NBC 2016 at BIS level in April 2026. Most state bye laws still refer to the older edition, and states such as Karnataka and Tamil Nadu add their own requirements on top. BildVisor keeps the editions apart, tells you which one is current at BIS level, and lets you work to whichever one your approval authority is actually asking for.
NBC 2016
Still referenced by most state bye laws
Same requirement, this edition
The clause text for this edition appears here, so you can read both side by side.
NBCS 2026
Current at BIS level
Same requirement, this edition
The clause text for this edition appears here, so you can read both side by side.
Who is on site, what they are doing, and what the record shows afterwards. Read off the same drawing as the fire layer.
level-03.dwgsecurity and access layersAlpha · example drawing
Camera and coverageControlled door7 cameras · 4 controlled doors
Sightlines
Sized to the site, not to a package
How many cameras a perimeter needs depends on what each one can actually see. A bundle of six is a price, not an answer.
One lens, two jobs
The camera watching for intruders can watch for smoke
AI detection cameras pick up flame and smoke in vision as well as movement. One install, two duties, which is why this layer belongs next to the fire layer rather than in a separate quote.
The record
Footage is personal data
Retention, who can pull a clip and when it is deleted carry rules under India's Digital Personal Data Protection Act 2023. Settle them before the system goes in, not after an incident.
The boundaryNo Indian Standard governs where a camera goes the way IS 2190 governs an extinguisher. BildVisor says so rather than inventing one.
S3 · Smart
One controller between the signals and everything they trigger.
Lighting that follows occupancy, power that follows schedule, and plant that runs itself. This is the shape that architecture takes.
Smart layer · schematicWhat BildVisor advises on
Signals inControllerActions out
On the premises
Decisions stay in the building
A control loop that has to cross a link to a data centre and back is a control loop with a single point of failure in someone else's building.
Two signals
One reading is not an event
Occupancy checked against daylight, a meter checked against the schedule it should be following. Cross-checking is what separates a real change from a blip.
Events only
What leaves the building
The record that goes off site is the event, not the raw feed. That is a bandwidth decision and a privacy one at the same time.
The boundaryBildVisor advises on these components and the standards that govern them. It is not the controller in the middle, and it does not operate your building.
S4 · Sustainable
Where each decision sits, and how long it stays open.
Carbon, energy and resilience close at different points in a building's life. Knowing which one you can still answer is most of the work.
Building lifecycle · where each decision sitsNo scores, no ratings
Open to changeExpensive to revisitIllustrative, not a measurement
Decided early
The expensive choices close first
Structure, envelope and plant selection are settled at design stage. After handover they are the ones nobody wants to reopen, whatever the intent was.
Demand first
A smaller demand is cheaper to meet
What the building asks for comes before what supplies it. Sizing plant to an unexamined load is how a building ends up paying for capacity it never needed.
Assumptions
Supply does not always behave
Grid, water and outside temperature all move. Resilience is mostly a question of which assumptions the design quietly made and what happens when one stops holding.
The boundaryFire and life safety has a clause behind every answer. Most of this does not. BildVisor says which parts are code and which are judgement, and does not rate or score your building.
Who it is for
One library, three desks around it.
The engineer who needs the clause, the professional who signs the drawing, and the manufacturer whose product ends up specified. Each one arrives for a different reason.
01
Fire safety consultants and officers
Reach the clause in seconds instead of minutes. Spend your time on the judgement call, not on finding the page.
02
Facility, EHS and safety managers
Know what your building is required to have, before an inspection tells you.
03
Contractors and system integrators
Size and specify systems with the standard open next to you, and see the equipment options in the same window.
04
Architects and MEP designers
Check fire and life safety requirements while the design is still cheap to change.
FAQ
Straight answers.
The questions architects, developers and fire consultants actually ask us first.
No. It is an engineering aid. Approval rests with your local authority and accountability rests with the qualified professional who signs the design.
The open Indian Standards for detection, suppression, pumps and extinguishers, along with the National Building Code. The library is growing, and you can request a standard from inside the product.
Yes. You choose the edition, and answers stay inside it.
Not in the free version. Licensed content stays with the professional who holds the licence, in a private library on their own account.
No.
Yes, on premise and fully air gapped deployments are available.
No. It gets you to the clause faster and, when you need a professional, it helps you find one.
No. It tells you what the standard requires, including type, rating, quantity and mounting height. Where each item sits on the drawing is a design decision that stays with your professional.
Still holding a question this page didn't answer?
Send the drawing instead. You will get the answer applied to your own project.
Send us your project details and get the gap report.
No demo call required first. Share a single drawing and we will return a marked-up plan and a compliance gap list, so you can judge the output on your own project rather than on a sales deck.
Marked-up drawing with placement and coverage
Clause-cited gap report, ranked by severity
Indicative bill of quantities
Your file deleted on request, always under NDA if you prefer